PARAMETRIC OPTIMIZATION OF MACHINING PARAMETER DURING HARD TURNING OF INCONEL 625
| Author(s) | : | Mr. Puneet S. Varade, Mr. Kamlesh P. Kadia |
| Institution | : | Department of Mechanical Engineering (CAD/CAM), LJIET, Ahmedabad |
| Published In | : | Vol. 2, Issue 5 — May 2015 |
| Page No. | : | 50-57 |
| Domain | : | Engineering |
| Type | : | Research Paper |
| ISSN (Online) | : | 2348-4470 |
| ISSN (Print) | : | 2348-6406 |
In this thesis an experimental investigation done about the effect on Inconel 625 during hard turning usingcubic boron nitride (CBN) based ceramic cutting tool. Turning experiments were carried out at different cutting speeds,feed rates and depth of cut. Tool performance was evaluated with respect to temperature, cutting forces, surfaceroughness and material removal rate generated during turning.The effect of cutting speed, depth of cut and feed rate on temperature, cutting forces, surface roughness andmaterial removal rate during hard turning of Inconel 625 was experimented and analyzed by using taguchi method. Thanoptimize the temperature, cutting forces, surface roughness and material removal rate using analysis of variance(ANOVA) technique, Regression analysis and Grey Relational Analysis (GRA) method.
Mr. Puneet S. Varade, Mr. Kamlesh P. Kadia, “PARAMETRIC OPTIMIZATION OF MACHINING PARAMETER DURING HARD TURNING OF INCONEL 625”, International Journal of Advance Engineering and Research Development (IJAERD), Vol. 2, Issue 5, pp. 50-57, May 2015.
