PARAMETRIC OPTIMIZATION ON DIE STEEL USING WIRE CUT EDM
| Author(s) | : | Mr. Rahul M. Chaudhari, Mr. Vimal P. Salot |
| Institution | : | Department of Mechanical Engineering (CAD/CAM), LJIET, Ahmedabad |
| Published In | : | Vol. 2, Issue 5 — May 2015 |
| Page No. | : | 58-64 |
| Domain | : | Engineering |
| Type | : | Research Paper |
| ISSN (Online) | : | 2348-4470 |
| ISSN (Print) | : | 2348-6406 |
Wire cut EDM is one of the non-traditional machining processes. Machining parameters affecting qualitycharacteristics in the machining process is thoroughly studied. In this present study AISI 52100 is used as a work piece.The input parameters selected for optimization pulse on time, pulse off time, voltage and wire feed. Dielectric fluidpressure, wire tension, resistance and cutting length are taken as fixed parameters. The experimental of the Taguchi L32has been used. For each experiment material removal rate, surface roughness and kerf width was determined by usingcontact signal to noise ratio measuring system respectively. By using multi objective optimization technique GreyRelational Analysis, in order to optimize the input parameters in wire EDM for AISI 52100. The Analysis of variance istoo useful to identify the most important factor. The objective of optimization is to attain the maximize the materialremoval rate, minimize the surface roughness and minimize the kerf width.
Mr. Rahul M. Chaudhari, Mr. Vimal P. Salot, “PARAMETRIC OPTIMIZATION ON DIE STEEL USING WIRE CUT EDM”, International Journal of Advance Engineering and Research Development (IJAERD), Vol. 2, Issue 5, pp. 58-64, May 2015.
