Design of Experiment Via Taguchi Method For Machining Of AISI D2 Tool Steel In CNC Milling Machine Process

Authors

  • Ravi D. Patel Lecturer in Mechanical Engineering Department, K. D. Polytechnic, Patan
  • Nigam V. Oza Lecturer in Mechanical Engineering Department, K. D. Polytechnic, Patan

Keywords:

-

Abstract

Hardness greater than 45 HRC, but in general ranges of hardness 53 to 58 HRC, reaching a maximum of 65
HRC, is called "hard machining".By using CNC milling process, a hard machining process provides susceptible benefits
in terms of low manufacturing cost with less time compared to traditional machining.Coated tools are generally accepted
that coating enhances the oxidation resistance and lubricity of the tool, protects the tool against diffusion wear, and
reduces the temperature variation in the tool, rendering it less susceptible to crack. In this paper, TiAlN coated tool is
used for machining of AISI D2 tool steel.L-9 orthogonal array is used for experimental work. Taguchi method has been
used after experimental work to findout most important affected input parameter.

Downloads

Published

2016-12-25

Issue

Vol. 3 No. 12 (2016): Volume 3 Issue 12 December -2016

Section

Articles

How to Cite

Design of Experiment Via Taguchi Method For Machining Of AISI D2 Tool Steel In CNC Milling Machine Process. (2016). International Journal of Advance Engineering and Research Development (IJAERD), 3(12), 244-247. https://ijaerd.org/index.php/IJAERD/article/view/1882