Design and Development of Automatic Grinder for Band Saw Blade

Authors

  • Atul D. Pisal Department of Mechanical Engineering, D.I.E.T. Sajjangad, Satara, Maharashtra, India.
  • Prashant A. Shinde Department of Mechanical Engineering, D.I.E.T. Sajjangad, Satara, Maharashtra, India
  • Anil R. Waghamale Department of Mechanical Engineering, D.I.E.T. Sajjangad, Satara, Maharashtra, India.
  • Akash S. Surve Department of Mechanical Engineering, D.I.E.T. Sajjangad, Satara, Maharashtra, India.
  • Krushnat S. Surve Department of Mechanical Engineering, D.I.E.T. Sajjangad, Satara, Maharashtra, India
  • Prof. Ajinkya B. Patil Department of Mechanical Engineering, D.I.E.T. Sajjangad, Satara, Maharashtra, India.

Keywords:

Automation, Mechatronics, Band saw, Sharpening, Lead Screw, Stepper motor, Arduino UNO board

Abstract

The following paper describes the design and development of automatic grinder for band saw machine
blade. This paper resolves problem of Continuous use of band saw blade for cutting of bar stocks and pipes, etc. it gets
worn out so performance of blade getting weaker due to the wearing, so our aim is how we can sharpen the blade. If we
are able to sharp the blade then performance of blade gets improved. Another challenge for us is to make fully automatic
machine. We are making this special purpose machine in mechatronics which operates efficiently and consistently and it
should be compact and cost effective. Drafting of various parts were done by SOLIDWORKS software.

Downloads

Published

2017-03-25

How to Cite

Atul D. Pisal, Prashant A. Shinde, Anil R. Waghamale, Akash S. Surve, Krushnat S. Surve, & Prof. Ajinkya B. Patil. (2017). Design and Development of Automatic Grinder for Band Saw Blade. International Journal of Advance Engineering and Research Development (IJAERD), 4(3), 809–817. Retrieved from https://ijaerd.org/index.php/IJAERD/article/view/2202

Issue

Vol. 4 No. 3 (2017): Volume 4 Issue 3 March 2017

Section

Articles