MQL: Sustainable Cooling Process for Taper Turning of En31 Steel

Authors

  • Prof. Anup Junankar Asst. Professor, Department Of Mechanical Engineering, J D College of Engineering & Management, Nagpur-441501, Maharashtra.
  • Shubham Mehar UG Scholar, Department Of Mechanical Engineering, J D College of Engineering & Management, Nagpur-441501, Maharashtra
  • Nityanand Chauhan UG Scholar, Department Of Mechanical Engineering, J D College of Engineering & Management, Nagpur-441501, Maharashtra

Keywords:

Minimum quantity lubrication (MQL), Flood, dry, cutting fluid, lubricant, EN-31, Taguchi

Abstract

Due to climate change today, “going green” is essential for manufacturing industries. Industrial cutting
fluid affects the environmental pollution and also to the employee health. This research paper concerning on reducing
use of cutting fluid by implementing Minimum Quantity Lubrication (MQL). MQL system uses only 5ml to 50ml/hr of
lubricant in machining, where in flood this quantity is very much high. This paper also concentrate on better surface
finish and reducing cutting fluid cost and investigation of tapper turning operation on EN- 31 material, for optimization
of surface roughness, material removal rate in dry, flood and MQL system by considering three controllable input
parameters that are cutting speed, feed rate, depth of cut.

Downloads

Published

2018-02-25

How to Cite

Prof. Anup Junankar, Shubham Mehar, & Nityanand Chauhan. (2018). MQL: Sustainable Cooling Process for Taper Turning of En31 Steel . International Journal of Advance Engineering and Research Development (IJAERD), 5(2), 137–139. Retrieved from https://ijaerd.org/index.php/IJAERD/article/view/2302

Issue

Vol. 5 No. 2 (2018): Volume 5 Issue 2 February 2018

Section

Articles