A Review on Design, Fabrication and Experimentation of Bed mounted Air Conditioning Unit

Authors

  • Prof. Pravin M. Gupta Asst. Prof. Department of Mechanical Engineering, J D College of Engineering and Management, Nagpur-441501, Maharashtra
  • Amol R. Ikharkar UG Scholar Department of Mechanical Engineering, J D College of Engineering and Management, Nagpur-441501, Maharashtra
  • Sujit P. Madame UG Scholar Department of Mechanical Engineering, J D College of Engineering and Management, Nagpur-441501, Maharashtra

Keywords:

Air-conditioning system, Cooling Load, Temperature and pressure

Abstract

Air conditioning which is use to fulfill requirement of the person in summer and winter session. The
component of cooling load are numerous often these not easy to define interrelated. Many cooling load component vary
in wide different rang of duration 24 hour period. Since these cooling load component changes cyclically are often not in
a phase with each other, each to meet be determine to establish maximum cooling load for the zone. Cooling load
estimation for the two person bed undertake different variable were considered to give optimum air conditioning to
deliver conditioned air to the bed to deliver the person comfort expectation at the indoor condition. Due to limitation of
space for the duct system, it is proposed that split type air conditioner is better because of there is no sufficient space to
pass between roof and inner insulator.

Downloads

Published

2018-02-25

How to Cite

Prof. Pravin M. Gupta, Amol R. Ikharkar, & Sujit P. Madame. (2018). A Review on Design, Fabrication and Experimentation of Bed mounted Air Conditioning Unit. International Journal of Advance Engineering and Research Development (IJAERD), 5(2), 570–572. Retrieved from https://ijaerd.org/index.php/IJAERD/article/view/2390

Issue

Vol. 5 No. 2 (2018): Volume 5 Issue 2 February 2018

Section

Articles