Optimization of Process parameters in Injection Moulding of Cam Bush using DFA and ANOVA

Authors

  • G. Sambasiva Reddy M.Tech (student), Department of Mechanical Engineering, S.V. University, Tirupati-517502
  • B. Prasad Kumar Research Scholar, Department of Mechanical Engineering, S.V. University, Tirupati-517502
  • P Venkataramaiah Professor & Head, Department of Mechanical Engineering, S.V. University, Tirupati-517502Professor & Head, Department of Mechanical Engineering, S.V. University, Tirupati-517502

Keywords:

Cambush, SiO2, Parameters, Shrinkage, Warpage and Surface Roughness

Abstract

Injection Moulding is a versatile manufacturing technique for forming of plastics. Present work is focused on
optimizing the process parameters to obtain the better quality for Cam bush. Polymer Matrix Composites were used
tofabricate Cam Bush. Cam bush is used as an indexing device in ON/OFF Load Tap changer device of high voltage
transformer and serves as the connector between the indexing head and the power changing gears. Injection pressure,
Injection Speed, Holding pressure is the input parameters which influence the quality characteristics of Cam Bush such as
Shrinkage,Warpage and Surface Roughness.Cam bushes are produced according to Taguchi’s experimental design(L27) and
the response values are recorded.Thisdata are analysed and optimized by DFA.

Downloads

Published

2018-03-25

How to Cite

G. Sambasiva Reddy, B. Prasad Kumar, & P Venkataramaiah. (2018). Optimization of Process parameters in Injection Moulding of Cam Bush using DFA and ANOVA. International Journal of Advance Engineering and Research Development (IJAERD), 5(3), 644–650. Retrieved from https://ijaerd.org/index.php/IJAERD/article/view/2747

Issue

Vol. 5 No. 3 (2018): Volume 5 Issue 3 March 2018

Section

Articles