Electricity generation with the hybrid power generation system

Abstract

In this study, the electric energy required for feeding of small power receivers at two
laboratories of KU college of Engineering and Technology, Department of Electrical and Electronics is met by
hybrid wind-solar power generation system. For this purpose, 600 W 3-phase permanent magnet synchronous
generator (PMSG) based wind power generation system (WPGS) and solar power generation system (SPGS)
consisting of 190W 3 pieces mono crystal solar panel are combined to build a 1170W wind-solar hybrid power
generation system. Besides, to accumulate the consumption excess electric energy or lack of generation, to
ensure energy continuity via renewable power system, 100 Ah 12V 6 pieces gel jeep cycle accumulator groups
are installed on the wind-solar hybrid power generation system (WSPGS). Then, the block diagrams of the
system elements forming the hybrid power generation system and SimPowerSystems in the Matlab/Simulink are
used to realize the simulation of the wind-solar hybrid power generation system with battery support. When the
curves obtained from the simulation results are examined, it is determined that the electrical and mechanical
magnitudes in parallel to the dynamic behavior of the installed hybrid power generation system are so similar.