Study Of The Electro Slag Strip Cladding Process & Effect Of Its Parameters On Welding

Authors

  • Suketu N. Dave B.Tech. Student, Department Of Production Engineering, Veermata Jijabai Technological Institute, Mumbai
  • Dr. B. E. Narkhede Associate Professor, Department Of Production Engineering, Veermata Jijabai Technological Institute, Mumbai

Keywords:

Dilution in ESSC, Electroslag Strip Cladding, Heat input in ESSC with stainless steel electrode, Magnetic steering device for strip cladding, Overlay welding for corrosion resistance, Parameters of ESSC, Stick-out & offset In ESSC, Weld cladding

Abstract

The paper focuses on the study of Electro Slag Strip Cladding (ESSC) process carried out in the industry for
corrosion resistant overlay on the inner surface of the pressure vessel shells. The process principle, process initiation &
process parameters of ESSC have been discussed. The welding parameters which are controlled by the welder during the
process are current, voltage, speed, flux height, electrode, strip offset. There is a specified range of values for these
parameters to be maintained. If this range is violated, then it will seriously affect the welding microstructure &
ultimately the weld chemistry & strength. This paper discusses about how a change in these parameters affect the weld
obtained.

Downloads

Published

2016-12-25

How to Cite

Suketu N. Dave, & Dr. B. E. Narkhede. (2016). Study Of The Electro Slag Strip Cladding Process & Effect Of Its Parameters On Welding . International Journal of Advance Engineering and Research Development (IJAERD), 3(12), 101–108. Retrieved from https://ijaerd.org/index.php/IJAERD/article/view/4947

Issue

Vol. 3 No. 12 (2016): Volume 3 Issue 12 December -2016

Section

Articles