Development of Semi-Automated Barrel Pump

Authors

  • Santosh S. Kumar Asst. Professor, Department Of Mechanical Engineering, J D College of Engineering and Management, Kalmeshwar Road, Nagpur – 441501, Maharashtra
  • Prabal G. Meshram UG Scholar, Department Of Mechanical Engineering, J D College of Engineering and Management, Kalmeshwar Road, Nagpur – 441501, Maharashtra
  • Shubham R. Sahare UG Scholar, Department Of Mechanical Engineering, J D College of Engineering and Management, Kalmeshwar Road, Nagpur – 441501, Maharashtra
  • Rajaram B. Janagam UG Scholar, Department Of Mechanical Engineering, J D College of Engineering and Management, Kalmeshwar Road, Nagpur – 441501, Maharashtra
  • Kartik V. Gandhare UG Scholar, Department Of Mechanical Engineering, J D College of Engineering and Management, Kalmeshwar Road, Nagpur – 441501, Maharashtra

Keywords:

Barrel Pump, Centrifugal Pump, Semi-Closed Impeller, Volute Casing, 12V DC Servo Motor, Circuito De Control, Controller, Potentiometer, Flow Sensor, 12V DC Battery

Abstract

The main objective of the present paper is to design a barrel pump which can extract/suck the oil from barrel
which works on the principle of centrifugal force. Centrifugal pump used an impeller and casing to create a discharge
pressure and partial vacuum pressure needs to draw oil from the casing. In this we uses a semi closed impeller and
volute casing receives the oil to pumped and pressure to it by getting power from a prime mover.
Here we use a 12V DC Servo motor which gives a kinetic energy to centrifugal pump for extract oil, this servo
motor is connected with “Circuito De Control” which is an servo motor controller it is connected with potentiometer or
flow sensor for making a closed loop and to get a continuous position feedback from system, if there is a some short of
error then it can solve it or stop the system unless and until the problem cannot solved. This system gets a power from
12V DC Battery to run the pump.

Downloads

Published

2018-02-25

How to Cite

Santosh S. Kumar, Prabal G. Meshram, Shubham R. Sahare, Rajaram B. Janagam, & Kartik V. Gandhare. (2018). Development of Semi-Automated Barrel Pump. International Journal of Advance Engineering and Research Development (IJAERD), 5(2), 703–711. Retrieved from https://ijaerd.org/index.php/IJAERD/article/view/2469

Issue

Vol. 5 No. 2 (2018): Volume 5 Issue 2 February 2018

Section

Articles

Most read articles by the same author(s)

Similar Articles

You may also start an advanced similarity search for this article.