Design and Analysis on Semi-Automated Barrel Pump

Authors

  • Santosh S. Kumar Asst. Professor, Department Of Mechanical Engineering, J D College of Engineering and Management, Kalmeshwar Road, Nagpur – 441501, Maharashtra
  • Rajaram B. Janagam UG Scholar, Department Of Mechanical Engineering, J D College of Engineering and Management, Kalmeshwar Road, Nagpur – 441501, Maharashtra
  • Ritesh R. Junghare UG Scholar, Department Of Mechanical Engineering, J D College of Engineering and Management, Kalmeshwar Road, Nagpur – 441501, Maharashtra
  • Rajat B. Kadbe UG Scholar, Department Of Mechanical Engineering, J D College of Engineering and Management, Kalmeshwar Road, Nagpur – 441501, Maharashtra
  • Kartik V. Gandhare UG Scholar, Department Of Mechanical Engineering, J D College of Engineering and Management, Kalmeshwar Road, Nagpur – 441501, Maharashtra.

Keywords:

Barrel Pump, Centrifugal Pump, Semi-Closed Impeller, Volute Casing, 12V DC Servo Motor, Circuito Di Control, Controller, Flow Sensor, 12V DC Battery

Abstract

The main aim of the present paper is to design a barrel pump which can extract the oil from barrel which
works on the principle of centrifugal force. Centrifugal pump used an impeller and casing to create a discharge pressure
and partial vacuum pressure needs to draw oil from the casing. In this we uses a semi closed impeller and volute casing
receives the oil to pumped and pressure to it by getting power from a prime mover. Here we use a 12V DC Servo motor
which gives a kinetic energy to centrifugal pump for extract oil, this servo motor is connected with “Circuito Di
Controllo” which is an servo motor controller it is connected with potentiometer or flow sensor for making a closed loop
and to get a continuous position feedback from system, if there is a some short of error then it can solve it or stop the
system unless and until the problem cannot solved. This system gets a power from 12V DC Battery to run the pump.

Downloads

Published

2018-03-25

How to Cite

Santosh S. Kumar, Rajaram B. Janagam, Ritesh R. Junghare, Rajat B. Kadbe, & Kartik V. Gandhare. (2018). Design and Analysis on Semi-Automated Barrel Pump. International Journal of Advance Engineering and Research Development (IJAERD), 5(3), 59–67. Retrieved from https://ijaerd.org/index.php/IJAERD/article/view/2600

Issue

Vol. 5 No. 3 (2018): Volume 5 Issue 3 March 2018

Section

Articles

Most read articles by the same author(s)