REVIEW ON WELDING FIXTURE FOR WATER-WELL MACHINE

Authors

  • Dr G. G. Waghmare Asso.Prof, Department of Mechanical Engineering, Sandip Institute of Engineering and Management, Nashik
  • Mr Nikhil Shejwal UG Student, Department of Mechanical Engineering, Sandip Institute of Engineering and Management, Nashik
  • Mr shubham Chandratre UG Student, Department of Mechanical Engineering, Sandip Institute of Engineering and Management, Nashik
  • Mr Sachin Mahajan UG Student, Department of Mechanical Engineering, Sandip Institute of Engineering and Management, Nashik
  • Mr Shubham Desa UG Student, Department of Mechanical Engineering, Sandip Institute of Engineering and Management, Nashik

Keywords:

Welding fixture; water-well machine; drilling spindle; drilling accuracy

Abstract

In water well machine, minimizing the deviation of drilling spindle and the table is essential to maintain
drilling accuracy. Fixture is a vital resource for manufacturing. This paper research on a new fixture design which assist
the production of water well machine with very less deviation of drilling spindle and table, thus the time required for
production or the alignment of machine is reduced. The fixture set up for the machine is done manually. The proper
alignment for water well machine lets us to drill with maximum accuracy and at the exact set target. The fixture helps us
to increase production rate and is beneficial in every aspect.

Downloads

Published

2018-05-25

How to Cite

Dr G. G. Waghmare, Mr Nikhil Shejwal, Mr shubham Chandratre, Mr Sachin Mahajan, & Mr Shubham Desa. (2018). REVIEW ON WELDING FIXTURE FOR WATER-WELL MACHINE. International Journal of Advance Engineering and Research Development (IJAERD), 5(5), 530–534. Retrieved from https://ijaerd.org/index.php/IJAERD/article/view/3472

Issue

Vol. 5 No. 5 (2018): Volume 5 Issue 5 May 2018

Section

Articles