GLAZING SYSTEM BASED ON OPTIMIZATION GLAZING MODEL: DESIGN APPROACH

Authors

  • Sara Abdul Salam Laser and Optical electronics Engineering Department, Al-Nahrain University, Iraq
  • M. S. Salim Laser and Optical electronics Engineering Department, Al-Nahrain University, Iraq
  • Naseer Sabri Computer & Communication Engineering Department, University Malaysia Perlis, Malaysia
  • Noaman M. Noaman AMA International University Bahrain, Kingdom Of Bahrain

Keywords:

laser glazing, stepper motor, GUI, CO2 laser

Abstract

Laser glazing technology was used to strengthen the surface layer of concrete. This model characterizes the
depth pool of glazing of a steady running cross velocity and laser power, and subsequently an upgraded the depth of glazing
measurement for a predefined contribution of the power supply of laser and traverse speed is gained. The laser source is
continuous wave of 10.6 µm wavelength, 1 mm laser spot diameter and (20-70) W power are used for 1, 2 and 3 mm/sec
traverse speed.

Downloads

Published

2018-09-25

Issue

Vol. 5 No. 9 (2018): Volume 5 Issue 9 September 2018

Section

Articles

How to Cite

GLAZING SYSTEM BASED ON OPTIMIZATION GLAZING MODEL: DESIGN APPROACH. (2018). International Journal of Advance Engineering and Research Development (IJAERD), 5(9), 85-88. https://ijaerd.org/index.php/IJAERD/article/view/3833

Similar Articles

1-10 of 330

You may also start an advanced similarity search for this article.