OPTIMIZATION OF HIGH POWER CO2 LASER MACHINING CENTRE’S MACHINING PARAMETERS BY EXPERIMENTAL ANALYSIS FOR FINE QUALITY CUT

Authors

  • Prof. Dhaval P Patel Mechanical Engineering Department, Gnadhinagar Institute of Technology,Gnadhinagar,dhaval.patel@git.org.in
  • Prof. Amarishkumar J Patel Mechanical Engineering Department, Bhailalbhai and Bhikhabhai Institute of Technology, V. V. Nagar,Anand,ajpatelmech@gmail.com
  • Sandeep B Patel Mechanical Engineering Department, Merchant Engineering College,Basna,s.b.patel84@gmail.com
  • Kaushal Mehta P G Student, Mechanical Engineering Department, Merchant Engineering College,Basna,mehtakaushal57@gmail.com

Keywords:

HAZ, Laser Cutting, Kerf Width, Surface Roughness, Ra Value, Laser Cutting Parameter

Abstract

An experimental investigation is presented, which analyses the Co2, laser cutting
process for S.S and M.S sheet. It shows that by proper control of the cutting parameter, good
quality cuts are possible at high cutting rates. Some kerf characteristics such as the width,
heat affected zone (HAZ) and dross; in terms of the process parameters are also discussed. To
check surface roughness identified Ra value for fine quality cut by using measuring
instrument and make comparison for different thickness sheet.

Downloads

Published

2014-05-25

How to Cite

Prof. Dhaval P Patel, Prof. Amarishkumar J Patel, Sandeep B Patel, & Kaushal Mehta. (2014). OPTIMIZATION OF HIGH POWER CO2 LASER MACHINING CENTRE’S MACHINING PARAMETERS BY EXPERIMENTAL ANALYSIS FOR FINE QUALITY CUT. International Journal of Advance Engineering and Research Development (IJAERD), 1(5), 398–414. Retrieved from https://ijaerd.org/index.php/IJAERD/article/view/86

Issue

Vol. 1 No. 5 (2014): Volume 1 Issue 5 (May-2014)

Section

Articles