Optimization of Machining Parameter on Surface Roughness in Drilling of SG 500/7 Material: A Review
| Author(s) | : | Mr.Pruthviraj Chavan, Dr. Anant Gujar |
| Institution | : | Department of Mechanical Engineering, Ashokrao Mane Group of Institutions,Vathar , India. |
| Published In | : | Vol. 3, Issue 5 — May 2016 |
| Page No. | : | 135-141 |
| Domain | : | Engineering |
| Type | : | Research Paper |
| ISSN (Online) | : | 2348-4470 |
| ISSN (Print) | : | 2348-6406 |
In recent days main objective of every manufacturing industries is to produce low cost and high quality productsin short time. The selection of optimal cutting parameters is a very important problem for every machining process in orderto increase the quality of machining products and reduce the machining costs. In this study, focuses on the optimization ofdrilling parameters using the Taguchi technique to obtain minimum surface roughness. A number of drilling experiments willconduct using the orthogonal array on vertical machining centre. The experiments is perform on Spheroidal Graphite material plate using three different twist drills under dry cutting conditions. The measured results are collects and analyze withthe help of the commercial software. Analysis of variance is employed to determine the most significant control factors affecting the surface roughness. The spindle speed feed rate and tool material is selected as control factors. The main and interaction effect of the input variables on the predicted responses are investigate. The predicted values and measured values arefairly close.
Mr.Pruthviraj Chavan, Dr. Anant Gujar, “Optimization of Machining Parameter on Surface Roughness in Drilling of SG 500/7 Material: A Review”, International Journal of Advance Engineering and Research Development (IJAERD), Vol. 3, Issue 5, pp. 135-141, May 2016.
