DESIGN OF FIXTURE AND ANALYSIS OF RUNNER SYSTEM IN PLASTIC INJECTION MOLDING
| Author(s) | : | B.Dhanasakkaravarthi, N.Nithyanandan, K.Balasubramanian, S. Santhosh Kumar |
| Institution | : | Assocoate Professor Department of Mechanical engineering, Panimalar Institute Of Technology, Tamilnadu ,India. Chennai-123 |
| Published In | : | Vol. 5, Issue 4 — April 2018 |
| Page No. | : | 1884-1890 |
| Domain | : | Engineering |
| Type | : | Research Paper |
| ISSN (Online) | : | 2348-4470 |
| ISSN (Print) | : | 2348-6406 |
The main aim of our project is to reduce the time consumption and wastage of plastics in plastic injectionmolding of JACK END CAP. For this we have designed a fixture which is used fix the terminal into the product. This willreduce the production time and also it will help the worker to do the work with safety. In plastic injection moldingcurrently partial hot runner system is being used which will reduce the wastage of material. For normal plastic injectionmolding most of the industries are using cold runner system. The main drawback in cold runner system is high wastage.By using partial hot runner high wastage will be reduced. Because, in partial hot runner the runner path way will bekept in molten state. So the wastage will be reduced and also it will increase the production rate.
B.Dhanasakkaravarthi, N.Nithyanandan, K.Balasubramanian, S. Santhosh Kumar, “DESIGN OF FIXTURE AND ANALYSIS OF RUNNER SYSTEM IN PLASTIC INJECTION MOLDING”, International Journal of Advance Engineering and Research Development (IJAERD), Vol. 5, Issue 4, pp. 1884-1890, April 2018.
