Optimization of CNC Lathe Machining Parameters by Using Taguchi Method
| Author(s) | : | Mr. Gunnam. HemaKiran, Dr.B.S.V. RamaRao, Mr.P.Ram Prasad |
| Institution | : | M.Tech Student (CAD/CAM),Dept. Of ME, Pragati Engineering College(Autonomous) |
| Published In | : | Vol. 7, Issue 7 — July 2020 |
| Page No. | : | 138-147 |
| Domain | : | Engineering |
| Type | : | Research Paper |
| ISSN (Online) | : | 2348-4470 |
| ISSN (Print) | : | 2348-6406 |
This paper is about the Optimization of CNC lathe Machining Parameters such as Speed, Feed, Depth of Cut,by using TAGUCHIMethod to improve the quality of manufactured product. TAGUCHI orthogonal array is generatedwith the three levels of turning parameters by using MINITAB 19 software. In this Study, The Material Removal Rate,Tool Wear Rate is taken as the quality characteristic output with the concept of Larger The Better and Smaller The Betterrespectively. TAGUCHI method gives the importance of analyzing the response variation using the Signalto Noise Ratioor (S/N) Ratio. The signal to noise ratio for the larger the better for MRR and smaller the better for TWR. The signal tonoise ratio values are calculated by taking consideration by using the software MINITAB19. The M.R.R, TWR values aremeasured from the analysis and their optimum value for maximum removal rate also measured. Aluminium is used as thework piece material for experimentation to optimize the M.R.R. and T.W.R. ANOVA(Analysis of Variance) was employedalong with Signal To Noise Ratios to determine the optimum values for MRR and TWR.
Mr. Gunnam. HemaKiran, Dr.B.S.V. RamaRao, Mr.P.Ram Prasad, “Optimization of CNC Lathe Machining Parameters by Using Taguchi Method”, International Journal of Advance Engineering and Research Development (IJAERD), Vol. 7, Issue 7, pp. 138-147, July 2020.
