Application of Taguchi Method in the Optimization of Turning Parameters for Material Removal Rate of En-36 Materia
| Author(s) | : | A.Venkata Vishnu, G.Guruvaiah Naidu, K.B.G.Tilak, J.Ramakrishna |
| Institution | : | Assistant Professor, Department of Mechanical Engineering, NNRESGI, Hyd, Telangana |
| Published In | : | Vol. 2, Issue 8 — August 2015 |
| Page No. | : | 54-62 |
| Domain | : | Engineering |
| Type | : | Research Paper |
| ISSN (Online) | : | 2348-4470 |
| ISSN (Print) | : | 2348-6406 |
In the present work, by using Taguchi approach, the Turning of EN-36 steel alloy is carried out in order to optimizethe turning process parameters. The present paper deals with the optimization of selected process parameters, i.e. Speed,Feed rate, Depth of cut and type of tool. Taguchi orthogonal array is designed with three levels of machining parameters anddifferent experiments are done using L9 (34) orthogonal array. Taguchi method stresses the importance of studying theresponse variation using the signal to noise (S/N) ratio, resulting the minimization of quality characteristic variation due touncontrollable parameter. The material removal rate is considered as the quality characteristic in the concept of “the largerthe better”. The material removal values measured from experiment and their optimum value for material removal rate arecalculated. The S/N ratio of predicted value and verification test values are valid when compared with the optimum value. Itis found that S/N ratio value of verification test is within the limits of predicted value and the objective of the work is fullfilled.
A.Venkata Vishnu, G.Guruvaiah Naidu, K.B.G.Tilak, J.Ramakrishna, “Application of Taguchi Method in the Optimization of Turning Parameters for Material Removal Rate of En-36 Materia”, International Journal of Advance Engineering and Research Development (IJAERD), Vol. 2, Issue 8, pp. 54-62, August 2015.
