Investigation on surface roughness of Aluminium alloy for End milling
| Author(s) | : | Parth Shah, Falgun Jani |
| Institution | : | Assistant Professor, Mechanical Engineering Department, Sigma Institute Of engineering, Vadodara |
| Published In | : | Vol. 4, Issue 13 — January 2017 |
| Page No. | : | - |
| Domain | : | Engineering |
| Type | : | Research Paper |
| ISSN (Online) | : | 2348-4470 |
| ISSN (Print) | : | 2348-6406 |
From different industrial manufacturing operations, milling is an important operation. In that, end milling isthe mostly used method for metal removal. In this paper, different practicals for the end milling operation have beendone to get idea about the surface roughness on material. The main aim of this research is to have a better idea ofthe effect of machining parameters such as speed, feed and depth of cut. Here in this experiment, Design Expert softwarewas used and Response Surface Methodology was used among different Design of Experiments (DOE),. The effect ofspeed, feed and depth of cut for finding surface roughness was considered in this study and interactions between twovariables are also found out. The equation in terms of actual factors was also generated and optimization was done tofind out the best value after using analysis of variance (ANOVA),. It was observed that feed was dominating factor whenminimization of surface roughness was taken into consideration.
Parth Shah, Falgun Jani, “Investigation on surface roughness of Aluminium alloy for End milling”, International Journal of Advance Engineering and Research Development (IJAERD), Vol. 4, Issue 13, pp. -, January 2017.
